Una guía para principiantes para configurar Hyper-V en Windows 10. Earlier I add Hyper-V component to my Windows (ventanas 10).
Simple Hyper-V configuration before use
1. I make some preparation and create folder in my Local Disk D:\ for storing VM’s files – Hiper-V;
2. Correr Administrador de Hyper-V Console (you can pin it to the taskbar);
3. En la consola abierta, vaya a Hyper-V Settings…
4. In my case at this point I configure only two parameters:
“Virtual Hard Disks” – set path to my folder “D:\Hyper-V” for storing vhdx’s;
“Virtual Machines” – set path to my folder “D:\Hyper-V” for storing VM’s config files;
5. After all changes press DE ACUERDO;
6. Next – config Virtual Switch. Ir a Virtual Switch Manager;
7. As first step create External Virtual Switch for enterprise network. Select type Externo y haga clic en Create Virtual Switch;
8. Ingresar Nombre of your Switch (in my case – Externo). Check connection type (External network), select your adapter and set check mark Allow management operating system to share this network adapter (in this case Network Adapter used for main system and for VM’s network traffic). After all changes – press Aplicar;
9. When you press apply – you get message about connection loosing, read message and press Sí. We create first Virtual Switch;
10. Second Virtual Switch – LAB network. Go back to New virtual network switch, seleccionar Private (network for communicate VM’s only with each other), prensa Create Virtual Switch;
11. Ingresar Nombre of Virtual Switch, select type Private network y presione DE ACUERDO;