Configuration Manager How to Install and Configure Distribution Point: Przewodnik krok po kroku.
Install Distribution Point
1. Open your SCCM Console. Idź do Administration\Overview\Site Configuration\Servers and Site System Roles;
2. Select your target server, select Distribution Point, and click Properties in the upper menu (Lub Prawy przycisk myszy and click Właściwości);
3. For the Ogólny patka. Jeśli używasz HTTP don’t forget to enable the checkmark Zezwalaj klientom na anonimowe łączenie się (or you get errors at OSD deployments); Choose the option Import certificate, select your Certyfikat, and enter Hasło;
4. Trzask Stosować and go to the PXE patka.
5. Dla . PXE tab. Enable check mark Enable PXE supports for clients when getting message click Tak (remember this message text, it may help you).
6. Enable check mark Allow this distribution point to respond to incoming PXE requests. Enable check mark Enable unknown computer support and click OK in the pop-up window;
7. If you have several network interfaces, you may choose who responds to PXE. Również, you may set PXE response delay if you need;
8. Trzask Stosować and go to the Multicast patka.
9. For the Multicast patka. Enable check mark Enable multicast to simultaneously send data to multiple clients;
10. Go to the Content Validation patka.
11. For the Content Validation patka. Enable check mark Validate content on a schedule;
12. Click the button Schedule and make configuration, when complete click OK;
13. Idź do Boundary Groups, if you already config groups for this DP you will see it here. Trzask OK;
14. After some time if you open Menedżer serwera you will notice, that the WDS role added;
Configure the Network Access Account
1. Open SCCM Console. Idź do Administration\Overview\Site Configuration\Sites. Select your site. Click in upper menu Settings\Configure Site Components\Software Distribution;
2. Idź do . Network Access Account tab, wybierz opcję Specify the account that access network locations;
3. Click on the “sun” button and choose New Account;
4. Enter your service account User name (also may click Przeglądać and select an account from Active Directory), Hasło I Confirm Password, trzask Verify;
5. Enter the path to a network share on the SCCM server (also may click Browse and select folder)and click Test connection. In the pop-up window click OK.
6. Trzask OK to close the Windows User Account window;
7. Account added, trzask OK;
