A Step-by-Step Guide to Configuring DHCP on Windows Server 2016 Using GUI and PowerShell.
With GUI
1. Run the DHCP console from the apps list. Navigate to IPv4\Server Options. There we config Server options for all scopes;
2. Desna tipka miša click at Server Options i kliknite Configure Options;
3. Select option 006 DNS Servers, enter an IP address, i kliknite Dodati;
4. Select option 015 DNS Domain Name, enter the domain name, i kliknite u redu;
5. New options added;
6. Desna tipka miša click at IPv4 i kliknite New Scope;
7. Click Sljedeći;
8. Unesi Ime (and if you wish Description), i kliknite Sljedeći;
9. Unesi the Start IP address, End IP address, i Subnet mask, i kliknite Sljedeći;
10. On this page, you may exclude the IP range from DHCP. Click Sljedeći;
11. Set Lease Duration i kliknite Sljedeći;
12. You may select Yes and configure Scope Options for this scope. I choose No, klik Sljedeći;
13. Click Završi;
14. Scope created, but we must Activate it;
15. Desna tipka miša click at the scope and click Activate;
16. Scope activated and worked!
17. If you Desna tipka miša kliknite na Leased IP Address, you may Add to the reservation Add to the filter, or even Delete it;
With PowerShell
1. Run PowerShell as Administrator. To get active scopes enter:
Get-DhcpServerv4Scope -cn <dhcp server name> | select scopeid, name, description
2. To add new scope, enter:
Add-DhcpServerv4Scope -Name ‘<scope name>’ -StartRange <start IP Address> -EndRange <end IP Address> -SubnetMask <subnet mask> -Description ‘<description>’ –cn <dhcp server name>
3. Before scope delete Best Practices is run the command with WhatIf parameter:
Remove-DhcpServerv4Scope -ScopeId <scope id> -cn <dhcp server name> -WhatIf
4. Then run without the WhatIf parameter:
Remove-DhcpServerv4Scope -ScopeId <scope id> -cn <dhcp server name>
5. Scope removed.