A Step-by-Step Guide to Configuring DHCP on Windows Server 2016 Using GUI and PowerShell.
With GUI
1. Løpe the DHCP console from the apps list. Navigate to IPv4\Server Options. There we config Server options for all scopes;
2. Høyre museknapp click at Server Options og klikk Configure Options;
3. Select option 006 DNS Servers, Tast inn an IP address, og klikk Legg til;
4. Select option 015 DNS Domain Name, enter the domain name, og klikk OK;
5. New options added;
6. Høyre museknapp click at IPv4 og klikk New Scope;
7. Klikk Neste;
8. Enter Navn (and if you wish Description), og klikk Neste;
9. Enter the Start IP address, End IP address, og Subnet mask, og klikk Neste;
10. On this page, you may exclude the IP range from DHCP. Klikk Neste;
11. Set Lease Duration og klikk Neste;
12. You may select Yes and configure Scope Options for this scope. I choose No, klikk Neste;
13. Klikk Bli ferdig;
14. Scope created, but we must Activate it;
15. Høyre museknapp click at the scope and click Activate;
16. Scope activated and worked!
17. If you Høyre museknapp click on Leased IP Address, you may Add to the reservation Add to the filter, or even Slett it;
With PowerShell
1. Løpe Kraftskall as Administrator. To get active scopes enter:
Get-DhcpServerv4Scope -cn <dhcp server name> | select scopeid, name, description
2. To add new scope, Tast inn:
Add-DhcpServerv4Scope -Name ‘<scope name>’ -StartRange <start IP Address> -EndRange <end IP Address> -SubnetMask <subnet mask> -Description ‘<description>’ –cn <dhcp server name>
3. Before scope delete Best Practices is run the command with WhatIf parameter:
Remove-DhcpServerv4Scope -ScopeId <scope id> -cn <dhcp server name> -WhatIf
4. Then run without the WhatIf parameter:
Remove-DhcpServerv4Scope -ScopeId <scope id> -cn <dhcp server name>
5. Scope removed.